E-flite Deuces Wild 25e2 ARF User Manual
Page 23
Advertising
23
E-flite Deuces Wild Assembly Manual
8. Secure the connector using a nylon connector
backplate. You may trim the servo horn with side cutters
to remove the unused arms if you choose.
9. Install the servo horn on the flap servo. The horn is
shown installed in the up flap position.
10. Slide a silicone clevis retainer onto each of the two
clevises required for the flap linkage. Thread the clevises
onto the flap linkage.
11. Attach the clevises to the flap control horns. The
wire will then slide into the brass pushrod connector
on the servo. You may need to use pliers to make a
slight bend in the linkage so it will not bind when the
flaps are in operation.
Advertising