E-flite Deuces Wild 25e2 ARF - Manual (Page 26)

26 E-flite Deuces Wild Assembly Manual
Fixed Gear Installation
Required Parts
Wing center section Fuselage assembly
Main gear (right and left) Nose gear
Nylon clevis Brass pushrod connector
Silicone clevis retainer 3mm x 5mm machine screw
Nylon connector backplate
29 3/4-inch (755mm) pushrod wire
3mm x 8mm self-tapping countersink screw (12)
Required Tools and Adhesives
Pencil Phillips screwdriver: #1, #2
Drill Pin drill
Thin CA Side cutter
Threadlock Sandpaper
Drill bit: 5/64-inch (2mm), 3/32-inch (2.5mm)
Note: There is a left and right main gear unit. Please note
that the coil on the wire should be to the aft side and the
wheel towards the center of the wing.
 1. Position the main landing gear in the opening in
the wing. Use a pencil to transfer the locations for the
mounting screws on to the landing gear rails. Please
ensure you center the main landing gear unit on the
mounting rails.
Note: Due to the model being designed for retracts and
fixed gear, you might need to slightly sand the flashing
off the edges of the fixed gear mounts to ensure an
interference free fit in the wing.