E-flite Deuces Wild 25e2 ARF - Manual (Page 41)

41 E-flite Deuces Wild Assembly Manual
Hint: Cut the string routed through the wing into two
pieces and tape them to the wing as shown to keep them
out of the way during the retract servo install.
 2. Position the retract servo in the wing. Use a pencil to
transfer the locations for the servo mounting screws to the
servo tray.
 3. Use a pin drill and 1/16-inch (1.5mm) drill bit to drill
the four holes for the servo mounting screws.
 4. Apply 2–3 drops of thin CA into each of the holes to
harden the surrounding wood. This will provide a harder
surface for the screws to bite into when installed.