E-flite Deuces Wild 25e2 ARF User Manual
Page 12
Advertising
12
E-flite Deuces Wild Assembly Manual
7. Next, slide the pushrod keeper onto the wire. Slide
the horn and keeper down so the horn it tight against
the bend.
8. The notch in the pushrod keeper will snap onto the
pushrod wire. This will keep the pushrod secure on the
servo horn. You may need to use pliers to apply enough
force to snap the pushrod keeper onto the wire.
9. Use side cutters to remove any excess wire that
extends beyond the connector. Leave a small amount of
wire to prevent the keeper from popping off accidentally.
10. Rotate the pushrod wire 90 degrees so the servo
horn aligns with the servo output shaft. Use a #1 Phillips
screwdriver to reattach the servo horn to the elevator
servo at the center position.
Advertising