E-flite Deuces Wild 25e2 ARF - Manual (Page 30)

30 E-flite Deuces Wild Assembly Manual
 14. Slide the brass pushrod connector in the hole drilled
in the previous step.
 15. Secure the connector to the servo horn using a
nylon connector backplate.
 16. Use the radio system to center the steering servo.
Slide the brass connector onto the wire then secure it to
the steering servo. After centering the nose wheel, use a
3mm x 5mm machine screw to secure the pushrod wire
to the connector. Use threadlock on the machine screw
to ensure it will not vibrate loose during flight. You may
wish to trim the unused arms from the servo horn with a
pair of side cutters to ensure nothing interferes with servo
operation. Now check to ensure the nose wheel turns left
when you apply left rudder.
Note: If you need to adjust the steering so your model
tracks straight on the runway, use this screw to do so.
Use the rudder trim at the radio to correct for rudder trim
in the air only. You may wish to trim the pushrod wire
with side cutters once you have finalized the setting and
nose wheel steering adjustment.