Dako Autostainer - Manual (Page 120)

120 Dako Autostainer | User Guide
Symptom Possible Cause Solutions
All the printer LEDs are on
steadily (not blinking).
The printer has a hardware
error.
Disconnect the printer from the
surge protector and wait 1
minute before reconnecting. If
all three LEDs come back on,
contact your local Dako
representative.
The printer is not feeding
properly or jams frequently.
Paper was added to the Paper
Input Bin incorrectly.
Remove the paper from the
Paper Input. Tap the sides of
the stack together and reinsert
into the bin.
The paper Input Bin is too full.
Remove some of the paper. The
Paper Input Bin can hold up to
100 sheets of regular weight
paper.
Paper was poorly cut by the
paper manufacturer and is
sticking together.
Although fanning the paper is
not generally recommended, it
may be an effective way to
decrease multi-feeds if the
paper was poorly cut and
sticking together.
You may also try turning the
paper around to feed the
opposite end first.
The output capacity was
exceeded in the Paper Output
Bin or the Front Output Slot.
Do not allow more than 100
sheets of
20 lb. Bond weight paper (less
for heavier media) to stack in
the Paper Output Bin.