Dako Autostainer User Manual
Page 90
90
Dako Autostainer
|
User Guide
2. Select
the
START RUN button. The RUN LOG screen is displayed.
The elapsed, remaining and total times are listed on the RUN LOG screen.
The Start, Current, Finish, and Batch times are also listed. The current step, total and
current time are always displayed in blue at the bottom of the Run Log.
NOTE: If the current time is not accurate do not change it during the run. Adjust the
time at the completion of the run. To reset time refer to the Windows 95/98
documentation.
If Substrate-Batch is used, the Batch Time is listed as the +HH:MM required to apply
all reagents except for the substrate. The calculated batch time is also displayed.
NOTE: The slides are rinsed with buffer every 30 minutes until the staining run
begins. After the completion of the run, the slides will be rinsed with DI water every
60 minutes until the slides are removed from the Autostainer.