Dako Autostainer Plus - Manual (Page 117)

Dako Autostainer Plus | User Guide 117
Symptom Possible Causes Solutions
Monitor will not turn on or goes
blank intermittently (power
LED is not on). The monitor is unplugged at the
power source. Check the power cord
connections and verify the
surge protector is plugged in
and turned on.
The monitor screen is not
displaying normally. The cable between the monitor
and the computer is not
connected properly. Disconnect and reconnect the
cable between the monitor and
the computer.
Monitor screen went blank
(power LED is green). Screen saver utility installed. Move the mouse. Current
screen will reappear. Remove
screen saver as this may
interfere with the Autostainer
Plus operation.
Monitor screen went blank
(power LED is orange). The cable between the monitor
and the computer is not
connected properly. Disconnect and reconnect the
cable between the monitor and
the computer.
Words on your monitor screen
are too dim. The brightness control is not
set properly. Adjust the brightness control.
Monitor screen locks-up during
a run, but the Autostainer Plus
is still performing the run. Windows error. Allow the Autostainer Plus to
finish the run. Re-boot the
system before the next run.