Dell PowerEdge M820 (for PE VRTX) - Manual (Page 102)

Error Code Message Information
HWC5031
Message IO module <number> is offline.
Details The CMC has powered off the IOM.
Action If the issue persists, see Getting Help .
HWC5032
Message A fabric mismatch detected on IO module <number>.
Details The fabric type for IOM's on the same chassis fabric must
match.
Action Check chassis fabric type in CMC GUI and compare to the
type of both IOM's.
HWC5034
Message A link tuning failure detected on IO module <number>.
Details Link tuning table not supported for this IO modular.
Action Update the CMC firmware. If the issue persists, see Getting
Help .
HWC5036
Message A failure is detected on IO module <number>.
Details The IOM module performance may be impacted.
Action If the issue persists, see Getting Help .
HWC6000
Message The <name> controller is offline.
Details Information and status from the controller is unavailable.
Action Remove and reapply input power. If the issue persists, see
Getting Help .
HWC6002
Message The <name> controller is stuck in boot mode.
Details Information and status from the controller is unavailable.
Action Remove and reapply input power. If the issue persists, see
Getting Help .
HWC6003
Message The <name> controller is booting.
HWC6004
Message Cannot communicate with <name> controller.
Details Information and status from the controller is unavailable.
102