Dell PowerEdge M820 (for PE VRTX) - Manual (Page 39)

8. Close the server module.
9. Install the server module in the enclosure.
Network Daughter Card/LOM riser card
Removing the Network Daughter Card/LOM riser card
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Remove the server module from the enclosure.
2. Open the server module.
3. Remove the two screws that secure the Network Daughter Card/LOM riser card to the system board.
4. Lift the card from the system board.
5. Close the server module.
6. Install the server module in the enclosure.
Figure 13. Removing and installing the network daughter card/LOM riser card
1. LOM riser card 2. screws (2)
3. LOM riser card connector 4. standoffs (2)
5. tab projections (on the plastic bracket
covering the PCIe mezzanine card
connectors)
39