Dell PowerEdge M820 (for PE VRTX) - Manual (Page 52)

When the board assembly is installed correctly, the tabs on the system board pan snap into the
corresponding openings in the floor of the server module chassis.
3. Replace the PCIe mezzanine cards in their original locations.
4. Reinstall the hard-drive backplane(s).
5. Replace the hard drives/SSDs.
Ensure that you reinstall the hard drives/SSDs in their original locations.
6. Reinstall the cooling shroud.
7. Install the SD card(s).
8. Close the server module.
9. Remove the plastic I/O connector covers from the back of the server module.
10. Install the server module in the enclosure.
11. Import your new or existing iDRAC Enterprise license. For more information, see the iDRAC7 User's
Guide, at dell.com/support/manuals.
System memory
Your system supports DDR3 registered DIMMs (RDIMMs) and load reduced DIMMs (LRDIMMs). It supports
DDR3 and DDR3L voltage specifications.
NOTE: MT/s indicates DIMM speed in MegaTransfers per second.
Memory bus operating frequency can be either 800 MT/s, 1066 MT/s , 1333 MT/s, 1600 MT/s, or 1866
MT/s depending on the:
• DIMM type (RDIMM or LRDIMM)
• DIMM configuration (number of ranks)
• Maximum frequency of the DIMMs
• Number of DIMMs populated per channel
• DIMM operating voltage
• System profile selected (for example, Performance Optimized, Custom, or Dense Configuration
Optimized)
• Maximum supported DIMM frequency of the processors
The system contains 48 memory sockets split into four sets of 12 sockets, one set per processor. Each
12-socket set is organized into four channels. In each channel, the release levers of the first socket are
marked white, the second socket black, and the third socket green.
NOTE: DIMMs in sockets A1 to A12 are assigned to processor 1, B1 to B12 to processor 2, C1 to C12
to processor 3, and D1 to D12 to processor 4.
52