Dell PowerEdge M820 (for PE VRTX) - Manual (Page 36)

Figure 11. Removing and installing the hard-drive/SSD backplane (half-length)
1. guide pins (3) 2. backplane connector
3. hard-drive/SSD backplane 4. hard-drive/SSD connectors (2)
5. guides (3)
Installing the hard-drive/SSD backplane
1. Remove the server module from the enclosure.
2. Open the server module.
3. Align the guides on the hard-drive/SSD backplane with the guide pins on the system board.
4. Press down the backplane until the connectors on the backplane and the system board are fully
engaged.
5. Install the hard drives/SSDs in their original locations.
6. Close the server module.
7. Install the server module in the enclosure.
36