Dell PowerEdge M820 (for PE VRTX) - Manual (Page 65)

NOTE: The storage controller card is located underneath the drive bays.
NOTE: The storage controller card is installed on the system board connector labeled as MiniPERC
CARD.
Removing the storage controller card
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To ensure proper system cooling, a storage controller blank must be installed on the
storage controller card connector that is not occupied. Remove the storage controller blank only
if you intend to install a storage controller card.
1. Remove the server module from the enclosure.
2. Open the server module.
3. Remove the system board and place it on the work surface.
4. Remove the two screws from the storage controller card.
5. Pull the storage controller card straight up and out of the connector.
Figure 25. Removing and installing a storage controller card
1. screws (2) 2. storage controller card
65