Dell PowerEdge M820 (for PE VRTX) - Manual (Page 122)

Error Code Message Information
Action Verify the input source is attached to the power supply.
Verify the input power is within the operating requirements
for the power supply.
PSU0005
Message The power input for power supply <number> is outside of
the allowable range, but it is attached to the system.
Details The operating requirements for the power supply may be
found in this manual or on the power supply itself.
Action Verify the input power is within the operating requirements
for the power supply.
PSU0006
Message Power supply <number> type mismatch.
LCD Message Power supply <number> is incorrectly configured. Check
PSU.
Details Power supplies should be of the same input type and power
rating.
Action Install matched power supplies and review proper
configuration in this manual.
PSU0007
Message Power supply <number> is operating at 110 volts, and could
cause a circuit breaker fault.
Details A power supply that is designed to operate at 220V, but is
connected to a 110V power source requires additional
current for operation. The additional current may trip circuit-
breakers or cause other electrical issues with the input
source.
Action Check input power source and cabling. Use recommended
input power. Review this Manual. If the issue persists, see
Getting Help .
PSU0008
Message Power supply <number> voltage rating does not match the
system's requirements.
Details The system does not support mixed voltage power supplies.
Action Install a power supply with the correct voltage rating.
PSU0016
Message Power supply <number> is absent.
LCD Message PSU <number> is absent. Check PSU.
Details The supply has been removed or has failed.
122