Dell PowerEdge M820 (for PE VRTX) - Manual (Page 42)

6. Close the server module.
7. Install the server module in the enclosure.
8. Enter the System Setup and verify that the USB key is detected by the system.
Figure 15. Replacing the USB memory key
1. USB memory key connector 2. USB memory key
SD vFlash card
Replacing the SD vFlash card
1. Remove the server module from the enclosure.
2. If installed, remove the SD vFlash card from the card slot.
NOTE: The SD vFlash card slot is located underneath LOM riser card 1 and can be identified by
the SD vFlash card slot identification label.
3. To install the SD vFlash card, insert the contact-pin end of the SD card into the card slot on the
vFlash media unit with the card label side facing up.
NOTE: The slot is keyed to ensure correct insertion of the card.
4. Press inward on the card to lock it into the slot.
5. Install the server module in the enclosure.
42