Dell PowerEdge M820 (for PE VRTX) - Manual (Page 44)

Figure 17. Removing and installing a processor/DIMM blank
1. processor socket 2. processor/DIMM blank
3. tabs (4) 4. heat sink retention screws (4)
Installing a processor/DIMM blank
1. Remove the server module from the enclosure.
2. Open the server module.
3. If installed, remove the processor and heat sink.
4. Position the processor/DIMM blank on the system board with the holes on the tabs of the processor/
DIMM blank secured to the heat sink retention screws on the system board.
5. Install the cooling shroud.
6. Close the server module.
7. Install the server module in the enclosure.
44