BendixKing KLN 94 - Pilots Guide - Manual (Page 107)

KLN 94 Pilot’s Guide Chapter 3 Basic GPS Operation
3-65
lines of 16 characters each are available for the remarks. A combination
of up to 200 user-defined waypoints and airports may include remarks.
Letters, numbers, hyphens, and spaces may be used in the remark. If no
remarks have been entered for the user-defined waypoint, line 2 will dis-
play [Remarks].
To enter a user-defined waypoint remark on the USR 3 page:
1. Turn on the cursor and move it
until the cursor fills line 2 of the
screen (figure 3-176).
2. Select the desired character with
the right inner knob and use the
right outer knob to move the cur-
sor to the next character on the
line (figure 3-177).
3. Repeat step 2 as necessary to
complete line 2.
4. Press
F to approve line 2. The
cursor will automatically move to
the next line (see figure 3-178).
5. Use the right inner and outer
knobs to enter the text for line 3.
Press
F to approve line 3.
6. Use the same procedure to enter text and press F to approve line
4.
7. Turn the cursor off when you are finished creating the remark.
NOTE: If there are already 200 waypoints with remarks and an attempt is
made to enter a remark for a waypoint, a scratchpad message “Remarks
Full” is displayed. It is then necessary to delete remarks using the AUX 13
page before new remarks can be entered.
The Auxiliary 13 (AUX 13) page is a list of waypoints with associated
remarks. If you wish to delete a waypoint remark for a user-defined way-
point, see section 5.11.
Figure 3-176
Figure 3-177
Figure 3-178