BendixKing KLN 94 - Pilots Guide - Manual (Page 18)

KLN 94 SNEAK PREVIEW
If you absolutely can’t wait to use your KLN 94 until you’ve read this Pilot’s
Guide, this section is for you. This short section will teach you just enough
to get going and then learn by doing. This operational preview assumes
the KLN 94 has been properly installed, the unit was previously opera-
tional in the same general geographical location, and that no peripheral
equipment interfaced with the KLN 94 (such as external HSI’s, CDI’s,
autopilots, moving map display, etc.) is to be used at this time. If you are
using this operational preview in flight, do so only in good VFR conditions
and only with an alternate means of navigation available to cross-check
position.
1. Turn the unit on by pressing the On/Off/Brightness knob (the small
knob in lower left hand corner). After the screen changes to full color,
rotate the knob to adjust the display brightness to the desired level.
2. For about 50 seconds the Power On Page is displayed while the unit
runs a self-test. (If the unit is in the Take-Home mode a Take-Home
page is displayed. Press the
F button to acknowledge the Take-
Home mode). Afterwards, the Self-test Page is displayed. If the
KLN 94 is receiving an altitude from an encoding altimeter, the present
indicated altitude will be displayed on line 2. The bottom line should
display Pass with the cursor over a flashing Ok?. Press the
F but-
ton to approve the Self-test Page.
3. The Initialization Page will now be displayed. If the date and time are
incorrect by more than 10 minutes, refer to section 3.2 of this Pilot’s
Guide. The right side of the screen should show the identifier of the
nearest airport to the initial position, along with a radial and distance
from that airport waypoint. Press
F with the cursor flashing over
Ok? to approve the Initialization Page.
4. If your KLN 94 has been configured for VFR use only, the VFR page
will now be displayed to notify you of the VFR limitation. Press
F to
approve this page.
5. The Database Page is now displayed showing the date the database
expires or the date it expired. Press
F to acknowledge the informa-
tion displayed on this page.
Introduction
ii