BendixKing KLN 94 - Pilots Guide - Manual (Page 188)

To replace an existing approach:
1. Press the
P button. If necessary move the cursor over Select
Approach? and press
F to bring up the PROC 2 page.
2. The cursor will already be over the airport associated with the
approach loaded in FPL 0. If you wish to select another airport for an
approach move the cursor over the desired airport identifier in the list.
Or, you always have the option of moving the cursor to the blank field
at the end of the list and entering another airport identifier. Press
F.
3. Select the desired approach and IAF as before.
4. The APT 8 page showing the
approach waypoints now dis-
plays REPL FPL 0 APR? at the
bottom of the page (figure 6-17).
Press
F to acknowledge and
load the new approach into the
active flight plan.
An approach is deleted from the active flight plan using the FPL 0 page. It
is also possible to replace an existing approach from this page.
To delete an existing approach:
1. With the active flight plan (FPL
0) page being displayed, turn the
cursor on by pressing
B (fig-
ure 6-18).
2. Move the cursor so that it covers
the approach header at the top
of the approach procedure.
Once the cursor comes over the
approach header, it will automat-
ically change to read CHANGE
APPR? (figure 6-19). If you
press
F in this condition the
KLN 94 will bring up the APT 8 page that corresponds to the current
approach. At this point it is possible to select a different approach pro-
cedure for this airport, a different IAF, or both.
3. If you press the E button while
the cursor is over the approach
header it will change to read
DELETE APPR? (figure 6-20). If
you press
F now, the KLN 94
will remove the entire approach
Chapter 6 Approaches and DP/STARs
6-12
Figure 6-18
Figure 6-19
Figure 6-20
Figure 6-17