BendixKing KLN 94 - Pilots Guide - Manual (Page 227)

APPENDIX B - MESSAGE PAGE MESSAGES
XXXXX Deleted
From FPL 0 - The displayed waypoint has been deleted from the active
flight plan (FPL 0) when an approach, DP or STAR was added to FPL 0.
The pre-existing waypoint was deleted because adding the
APR/DP/STAR to the flight plan caused the same waypoint to be listed
consecutively in FPL 0. If the APR/DP/STAR is later deleted from FPL 0
the original waypoint can only be restored by manual re-entry.
Adj Nav Crs to XXX° - (Adjust navigation indicator course to XXX°)
When this message appears, you should select the suggested course on
the HSI or CDI. When the KLN 94 is in the Leg mode, this message
occurs during turn anticipation (prior to reaching the active waypoint) if the
upcoming course change is greater than 5° and anytime the indicator’s
selected course needs to be adjusted to match the KLN 94 desired track.
This message will only be displayed if the KLN 94 is installed such that it
can “read” the selected HSI or CDI course. See section 4.2.2.
Aero Database Outdated,
All Data Must be
Confirmed Before Use - This message appears when the aeronautical
database is out of date as a result of a date and time entered on the SET
2 page or Self-Test page or as a result of a pilot-entered date being over-
ridden by a date from the GPS receiver.
Airspace Alert
[name and type of special use airspace]
[altitude boundaries]
[responsible ATC facility] — This message appears when the estimated
time to enter a special use airspace (SUA) is approximately 10 minutes or
when the distance from an area of special use airspace is less than two
nautical miles. See section 3.13.
All Wpt Remarks Used,
Delete on AUX 13 Page - This message will be displayed if you attempt
to enter a waypoint remark and the user database already contains 100
waypoint remarks.
Altitude Fail - This message will be displayed if the altitude input
becomes invalid during operation.
APR ACTV Annunciator
Fail — This message appears when there is a failure of the KLN 94 exter-
nal ACTV annunciator drive circuitry. Service unit as soon as possible.
APR ARM Annunciator
Fail — This message appears when there is a failure of the KLN 94 exter-
nal ARM annunciator drive circuitry. Service unit as soon as possible.
KLN 94 Pilot’s Guide Appendix B Message Page Messages
B-1