BendixKing KLN 94 - Pilots Guide - Manual (Page 44)

output displayed on the unit’s internal course deviation indicator (CDI) and
provided to an external horizontal situation indicator (HSI) or CDI is five
nautical miles (full scale sensitivity) left and right in Leg mode. The other
modes are described in section 5.5 and chapter 6.
To turn on and initialize the KLN 94:
1. Turn on the KLN 94 by pushing in the On/Off/Brightness knob. For the
first few seconds a single color Power-On page is displayed at a fixed
brightness. When the screen changes to full color, rotate the knob to
adjust display brightness to the desired level.
After an additional few seconds,
the operational revision status
(ORS) level number is displayed
on the Power-On page (figure 3-
3). The ORS level displayed
should match the ORS level indi-
cated on the cover of this Pilot’s
Guide .
NOTE: If the temperature is very cold when the KLN 94 is turned on, a
Warm Up screen is displayed after the Power-On screen. Line 4 will dis-
play the approximate time the Warm Up screen will be displayed prior to
automatically changing to the Power-On screen. The
E button may be
pressed to bypass the Warm Up screen but the display may be extremely
sluggish until it warms up.
When an extensive internal test
is complete, the Power-On page
will automatically be replaced by
the Self Test page (figure 3-4).
NOTE: If the KLN 94 is operating in
the Take-Home Mode, the Take-
Home Warning Page (figure 3-5) is
displayed first and must be acknowl-
edged by pressing
F. See section
3.16 for more information on the
Take-Home mode.
NOTE: A warning page (figure 3-6)
is displayed if the unit is turned on
without a database card.
Chapter 3 Basic GPS Operation
3-2
Figure 3-3
Figure 3-4
Figure 3-5
Figure 3-6