BendixKing KLN 94 - Pilots Guide - Manual (Page 59)

To see an example of a Duplicate Waypoint page, try entering the identifi-
er “AC” as a Direct To waypoint:
1. Press
D.
2. Select “AC” as the waypoint
identifier (figure 3-48). AC is the
full identifier of several waypoints
in the KLN 94 database.
3. Press
F. The Duplicate
Waypoint page will be displayed
on the screen (figure 3-49). At
the time of this writing, there
were three waypoints in the
Americas database having the
identifier AC. The list includes an
NDB in the southcentral U.S., an
NDB in the northeast U.S., and an NDB in Canada. The cursor will be
over the first waypoint listed. On the screen in figure 3-49, the NDB in
SC USA is closest to the aircraft’s present position since it is listed
first.
If there are more than four duplicates, view the rest of the choices by rotat-
ing the right outer knob clockwise. Doing so will move the flashing cursor
over waypoints two, three, and four and then will cause the waypoint list to
“scroll” so that the other waypoints in the list may be seen.
4. To select the desired waypoint,
move the cursor over the appro-
priate choice (figure 3-50).
5. Press F and the display will
change to the waypoint page for
the selected waypoint (figure 3-
51).
6. Press F again to approve the
waypoint page.
KLN 94 Pilot’s Guide Chapter 3 Basic GPS Operation
3-17
Figure 3-48
Figure 3-49
Figure 3-50
Figure 3-51