BendixKing KLN 94 - Pilots Guide - Manual (Page 159)

To calculate distance, bearing, time, and ESA from present position
to another waypoint:
1. From the AUX 4 page (figure 5-
58), turn on the cursor (
B). It
will appear over a field that either
displays Ppos, Fpl, or Wpts.
2. Turn the right inner knob to
change this field to Ppos.
3. Turn the right outer knob to
move the cursor over the To
waypoint field (figure 5-59)
4. Enter the desired “to” identifier
and press
F. You will be
shown the waypoint page for the waypoint you entered. Press
F
again to approve.
5. Select your estimated ground-
speed for the trip. As you
change it, the estimated time en
route (ETE) calculation will be
updated (figure 5-60).
To calculate distance, bearing, time , and ESA from waypoint to way-
point:
1. From the AUX 4 page, turn on the cursor (
B) and use the right inner
knob to select Wpts (figure 5-
61).
2. Turn the right outer knob clock-
wise to move the cursor to the
“from” waypoint in the upper
right corner of the screen (figure
5-62).
3. Enter the desired identifier for
the “from” waypoint and press
F. You will be shown the way-
point page for the waypoint you
entered. Press
F again to
approve.
4. With the cursor over the “to”
waypoint, enter the desired iden-
tifier (figure 5-63) and press
F
twice. The bearing will be dis-
KLN 94 Pilot’s Guide Chapter 5 Intermediate Operation
5-25
Figure 5-58
Figure 5-59
Figure 5-60
Figure 5-61
Figure 5-62
Figure 5-63