BendixKing KLN 94 - Pilots Guide - Manual (Page 146)

7. Use the right outer knob to move
the cursor, and the right inner
knob to select the proper num-
bers to complete the latitude
entry (figure 5-31).
8. Press F. The cursor will move
to the longitude field.
9. Enter the longitude in the same
manner as the latitude (figure 5-
32).
10. Press
F to approve this posi-
tion. The cursor will
automatically turn off (figure 5-
33).
5.4.3. CREATING A WAYPOINT REFERENCED FROM ANOTHER
WAYPOINT
The third method of creating a user-defined waypoint is as a radial and
distance from a known waypoint.
To create a user-defined waypoint using the radial/distance method:
1. From any user waypoint (USR) page, turn on the cursor (
B). It will
be over the first character in the waypoint identifier field.
2. Use the right inner knob to select the first character of the identifier.
Remember that when the cursor is on, the right inner knob changes
the character and the right outer knob moves the cursor around.
3. Spell out the rest of the identifier
using the right inner and outer
knobs (figure 5-34).
4. Move the cursor down to the
third line, over User Pos R/D?
(figure 5-35).
Chapter 5 Intermediate Operation
5-12
Figure 5-31
Figure 5-32
Figure 5-33
Figure 5-34
Figure 5-35