BendixKing KLN 94 - Pilots Guide - Manual (Page 219)

runway 17R so move the cursor
over RW17R (figure 6-69). Press
F. If the STAR does not
require a specific runway the
KLN 94 skips this step.
8. The KLN 94 now presents a list
of waypoints that make up the
STAR (figure 6-70). Review
these waypoints if desired and
then press
F to load the STAR
into the active flight plan.
9. The KLN 94 will then add the
STAR procedure before the air-
port identifier in the active flight
plan (figure 6-71). If the airport is
not included in the active flight
plan, then the KLN 94 will ask to
add this waypoint to the active
flight plan.
NOTE: It is not possible to load a DP or STAR into a flight plan other than
FPL 0. Furthermore, DP and STAR procedures are deleted from FPL0
after the power is off for more than 5 minutes.
6.3.3. EDITING A DP OR STAR
From the proceeding two examples you may have noticed that DP and
STAR procedures have procedure “headers” just as approaches do. It is
possible to use these headers to delete and change the entire procedure
just like is done with approach procedures. One difference between DP
and STAR procedures and approaches is that it is possible to add way-
points to and delete waypoints from the published procedure. To help you
differentiate between approaches (no adding or deleting waypoints
allowed) and DP or STAR procedures (adding and deleting waypoints
allowed) the waypoint number for a DP or STAR waypoint has a period (.)
next to it instead of a blank space. The period also differentiates a DP or
STAR waypoint from a “regular” waypoint that has a colon (:) next to the
waypoint number.
To add an individual waypoint in the DP or STAR procedure:
1. Use the right knobs to select the FPL 0 page.
2. Turn the cursor on by pressing the
B. Rotate the right outer knob as
necessary to position the cursor over the waypoint identifier which you
desire to follow the waypoint being added.
KLN 94 Pilot’s Guide Chapter 6 Approaches and DP/STARs
6-43
Figure 6-69
Figure 6-70
Figure 6-71