BendixKing KLN 94 - Pilots Guide - Manual (Page 113)

KLN 94 Pilot’s Guide Chapter 3 Basic GPS Operation
3-71
2. Note what the default number is next to “Comm” and “Nav”. In figure
3-190, the default number is 1 for both Comm and Nav.
3. Press the B button to turn on the cursor.
4. Rotate the right inner knob to view the comms configured for
QuickTune™. If only one number is displayed then it is the only comm
configured for QuickTune™.
5. Rotate the inner knob if necessary to display the number that was dis-
played in step 2 above.
6. Rotate the right outer knob to position the cursor over the number next
to “Nav”.
7. Rotate the right inner knob to view the navs configured for
QuickTune™. Select the number that was displayed in step 2.
8. Turn off the cursor.
3.15.1. QUICKTUNE™ OPERATION WITH ONE COMPATIBLE
NAV/COMM
To use the QuickTune™ feature when the KLN 94 is configured with
only one compatible Nav/Comm:
1. Turn on the cursor and use the right outer knob to position the cursor
over the desired frequency on an
APT 5, VOR 1, FSS 1, or CTR 1
page (figure 3-191). Remember
that on the APT 5 page you can
scroll the cursor through all of the
airport frequencies without hav-
ing to turn the cursor off and
back on to change pages.
2. Press the
F button to send the frequency to the KX 155A (or
KX 165A) comm or nav frequency standby window.
3. Press the appropriate comm or nav frequency transfer button when
ready to activate the frequency.
Figure 3-191