BendixKing KLN 94 - Pilots Guide - Manual (Page 53)

Display Segment 4 (Annunciations)
Segment 4 displays annunciations
associated with the operation of the
KLN 94 (figures 3-30 and 3-31).
Line one shows the WPT (waypoint
alert) annunciation when approach-
ing the active waypoint (see sections
3.10.3 and 4.2.2) or the SCAN
annunciation when the scan function
has been enabled. The scan function
is enabled by pulling the right inner
knob to the “out” position on pages
that allow waypoint lists to be
scanned by turning the right inner
knob.
Line two shows the message prompt, a large “M”, when the KLN 94 has a
message for you to view on the message page (see section 3.5 “Message
Page”). This line is also used to indicate that the KLN 94 is ready for you
to press the
F button to approve something, such as a selected way-
point, by flashing the ENT (enter) prompt.
Line three displays a white “VTF” when a vectors-to-final approach has
been loaded into the active flight plan (but not yet activated) and a green
“VTF” when the vectors-to-final approach has been activated (see section
6.2.8).
Lines four and five display if the unit is in either the approach arm (APR
ARM) or approach active (APR ACTV) modes (see section 6.2.1). The
KLN 94 may also be configured at the time of installation to display termi-
nal (TERM) and approach (APR), respectively, in lieu of APR ARM and
APR ACTV. If the KLN 94 is in the en route mode these lines are blank.
Line six will normally display “LEG” which is the default mode. “OBS” is
displayed when the pilot has selected the OBS mode (see section 5.5
“Navigation Modes”).
Either “LEG” or “OBS” is always displayed on line six. The other lines in
the annunciation segment will be blank unless the annunciation is active.
NOTE: The waypoint alert, message, and approach annunciations may
also be displayed on remote annunciators. See section 3.14 “Remote
Mounted Annunciators”.
KLN 94 Pilot’s Guide Chapter 3 Basic GPS Operation
3-11
Figure 3-30
Figure 3-31