BendixKing KLN 94 - Pilots Guide - Manual (Page 75)

The frequencies displayed on the nearest Center page are QuickTune TM
frequencies. When the cursor is positioned over a frequency displayed on
this page and the
F button is pressed, the frequency is automatically
inserted into the standby window of a Bendix/King KX 155A or KX 165A
Nav/Comm. (QuickTune
TM must be enabled in the installation for this to be
operational). QuickTune TM is described in section 3.15.
3.10. DIRECT TO OPERATION
The D button is used to initiate Direct To operation (navigation from
your present position direct to your destination). When
D is pressed, the
Direct To page will be displayed with
a flashing cursor over a waypoint
identifier (figure 3-94). The waypoint
identifier which appears on the
Direct To page is chosen by the
KLN 94 according to the following
rules:
1. If the Flight Plan 0 (FPL 0) page is displayed on the screen and the
cursor is over one of the waypoint identifiers in FPL 0 when
D is
pressed, then that waypoint identifier will appear on the DIR page.
You will appreciate this feature when you learn to use flight plans in
section 4.2.
2. If the KLN 94 is displaying the NAV 4 page and the right inner knob is
in the “out” position, then the waypoint highlighted in the lower right
hand corner of the NAV 4 map display will be the default waypoint.
You will also find this feature useful when operating from the active
flight plan especially during approaches with the KLN 94.
OR . . .
3. If there is any waypoint page (APT, VOR, NDB, INT, USR, or ACT
page) in view when
D is pressed, then the DIR page will contain the
identifier for the waypoint just viewed.
If none of the conditions above are occurring, then:
4. When
D is pressed, the waypoint identifier for the current active
waypoint will be displayed. However, if the KLN 94’s active waypoint
is the Missed Approach Point and the aircraft has flown past the MAP,
then the KLN 94 will display the first waypoint of the missed approach
procedure on the Direct To page.
If there is no active waypoint when
D is pressed, then:
5. The Direct To page displays a blank cursor field. In order for there not
to be an active waypoint, there is no Direct To waypoint and there are
no waypoints in Flight Plan 0.
KLN 94 Pilot’s Guide Chapter 3 Basic GPS Operation
3-33
Figure 3-94