BendixKing KLN 94 - Pilots Guide - Manual (Page 57)

4. Turn the right outer knob one
click clockwise to move the cur-
sor to the second character
position (figure 3-39).
5. Rotate the right inner knob to
select the second character (fig-
ure 3-40).
6. Use the right outer and inner
knobs in this manner until the
complete waypoint identifier is
displayed (figure 3-41). Note that
you may not have to enter the
last characters of the identifier
because each time you enter a
character, the KLN 94 offers you
the first identifier in the database
beginning with the characters
you have entered.
7. If ENT is flashing on the right
side of the screen, then press
F. This will prompt the
KLN 94 to display a waypoint
page for the waypoint identifier
you just entered (figure 3-42).
8. Verify the waypoint information
displayed, and then press
F
again to approve the waypoint
page. The display will return to
the page previously displayed
(figure 3-43).
Often, you will find yourself entering airports that begin with the same
character over and over again. In section 2.3, you learned how the
KLN 94 uses ICAO identifiers, which means that many U.S. airport identi-
fiers begin with the letter K. Also, many airport identifiers in Europe begin
with the letter E or the letter L. Especially when flying VFR, you will mostly
want to enter Direct To or Flight Plan waypoints which are airports. You
can set the default first waypoint identifier character on the SET 11 page.
KLN 94 Pilot’s Guide Chapter 3 Basic GPS Operation
3-15
Figure 3-39
Figure 3-40
Figure 3-41
Figure 3-42
Figure 3-43