BendixKing KLN 94 - Pilots Guide - Manual (Page 85)

• Nearest 20 user defined waypoints (USR) within 200 NM of the air-
craft
• Tower rings (TWR Rings). A tower ring is a 4 NM radius circle
drawn around airports having a control tower that operates at least
part time. Note that a tower ring is not Class D airspace which
usually consists of a 3 to 7 NM radius ring plus additional
extensions. Tower rings are not displayed for the primary airport
associated with class B, class C, CTA, or TMA airspace.
• Holding Patterns and Procedure Turns (Hold Pat) associated with
approaches, DPs and STARs. (ORS 02 and higher)
Each of the above items may be turned on or off individually. The item is
turned on by selecting the maximum map range scale you want the item
to be displayed. Therefore if the 5 NM map range scale is selected for
intersections, the intersections will be displayed on the map for range
scales 5 NM and smaller and will not be displayed on the map for range
scales greater than 5 NM.
To configure aeronautical data for the map:
1. Press the
M
button while view-
ing the NAV 4 map page to bring
up the map menu. The cursor
will already be over “Setup Aero
Data?” (figure 3-122).
2. Press the
F button. This
brings up the SET 7 page (figure
3-123).
NOTE: All aeronautical data may
be turned off by using the right outer
knob to position the cursor over the
field to the right of “AERO DATA: “
and then using the right inner knob
to select “OFF” (figure 3-124).
3. Use the right outer knob to posi-
tion the cursor over the field next
to the item to be configured.
Lines 4 and 5 are a scrolling
region so after positioning the
cursor over the VOR field, fur-
ther clockwise turns of the knob
will scroll down the list. To con-
figure intersections, position the
cursor over the distance field to
the right of INT (figure 3-125).
KLN 94 Pilot’s Guide Chapter 3 Basic GPS Operation
3-43
Figure 3-122
Figure 3-123
Figure 3-124
Figure 3-125