Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 101)

101
TPS1100 - User Manual 2.2.1en System parameters
6
10
12
21
26
45
Configuration parameters, continued
Compensator
ON Switches on the
compensator, which
measures the longitudinal
and transverse tilts of the
vertical axis. The V-angles
are relative to the plumb
line.
OFF Switches off the
compensator.
appears
in the status display. The V-
angles are relative to the
vertical axis.
The working range of the
two-axis compensator is 6'
(0.10 gon) for each axis.
Hz-Corr.
ON Switches on the Hz
correction.
The Hz measurements are
corrected for the following
errors:
1. Line-of-sight error
2. Tilting-axis error
3. Standing-axis tilt (only for
compensator ON).
OFF Switches off the Hz correction.
The Hz measurements are
not corrected.
appears in the status
display.
Examples of compensator / Hz
corrections:
1. Compensator ON, Hz corrections
ON.
The V-angles are relative to the
plumb line. The Hz measurements
are corrected for line-of-sight error,
tilting-axis error and standing-axis
tilt.
2. Compensator ON, Hz corrections
OFF
The V-angles are relative to the
plumb line. The Hz measurements
are not corrected for line-of-sight
error, tilting-axis error or standing-
axis tilt.
3. Compensator OFF, Hz corrections
ON
The V-angles are relative to the
standing axis. The Hz
measurements are corrected for
line-of-sight error and for tilting-
axis error.
4. Compensator OFF, Hz corrections
OFF
The V-angles are relative to the
standing axis. Hz corrections are
not applied.