Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 48)

48
TPS1100 - User Manual 2.2.1en Checking and adjusting
6
0
2
21
Adjusting the direction of the beam
Pull the two plugs out from the
adjustment ports on the top side of
the telescope housing.
To correct the height of the beam,
insert the screwdriver into the rear
adjustment port and turn it clockwise
(dot on target plate moves obliquely
upwards) or anticlockwise (dot
moves obliquely downwards).
To correct the beam laterally, insert
the screwdriver into the front
adjustment port and turn it clockwise
(dot moves to the right) or
anticlockwise (dot moves to the left).
Reflector-free EDM, continued
Throughout the adjustment
procedure, keep the
telescope pointing to the target plate.
After each adjustment,
replace the plugs in the ports
to keep out damp and dirt.
1100Z31
1100Z32