Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 93)

93
TPS1100 - User Manual 2.2.1en System functions
6
10
12
21
26
Illumination
Switches on the back lighting
and crosshair.
Settings for:
• Back lighting (display) on/off
• Heating of display on/off
• Contrast of display
• Brightness of crosshair illumination
• Brightness of EGL guide light (op-
tional)
• Eyepiece diode laser on/off (optio-
nal)
• Red laser on/off (optional)
The current settings are displayed
numerically as percentages and
graphically as a bar diagram.
Optional settings are possible only if
the instrument is additionally
equipped.
Switches the back lighting on
and off.
Switches the display heating
on and off.
Switches the crosshair
illumination on and off.
The assignment of the
function key depends on the
equipment installed:
Switches the guide light on and off
(EGL); key assignment "EGL+" .
Or:
Switches the eyepiece diode laser on
and off; key assignment "DIOD+".
Illumination
Display : ⌧ ⌧ ⌧ ⌧ ⌧
Heating : ⌧ ⌧ ⌧ ⌧ ⌧
Contrast : 50% ⌧ ⌧ ⌧ ⌧ ⌧
Reticule : 80% ⌧ ⌧ ⌧ ⌧ ⌧
EGL : 100% ⌧ ⌧ ⌧ ⌧ ⌧
RedLaser : ⌧ ⌧ ⌧ ⌧ ⌧
OK DISP+ HEAT+ RETI+ EGL+ RedL+
MC
DEFLT QUIT
Switches the visible red laser
on and off (only for TCR/
TCRM instruments).
WARNING:
(only for Extended Range
Instruments)
If the visible red laser is switched on
do not aim at prisms or reflecting
objects through or beside the optical
sight. Aiming against prisms is only
allowed by looking through the
telescope. Using the laser pointer is
only permissible within a controlled
area (refer to chapter "Safety
Directions").
Sets standard values
(contrast 50%,
crosshair 80%).
At extremely low
temperatures or in very
bright ambient light conditions the
contrast should be set to a higher
value than 50%.