Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 142)

142
TPS1100 - User Manual 2.2.1en Safety directions
6
FCC statement (applicable in U.S.)
WARNING:
This equipment has been
tested and found to comply
with the limits for a Class B digital
device, pursuant to part 15 of the
FCC rules.
These limits are designed to provide
reasonable protection against
harmful interference in a residential
installation.
This equipment generates, uses and
can radiate frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation. If
this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
This device complies with part 15 of the FCC Rules. Ope-
ration is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Product labeling: • Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and the receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
WARNING:
Changes or modifications not
expressly approved by Leica
Geosystems for compliance could
void the user's authority to operate
the equipment.
1100Z43
This device complies with part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.