Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 66)

66 System functions TPS1100 - User Manual 2.2.1en
After the instrument height and the
reflector height have been entered,
target the backsight point and measure
the distance and/or the direction.
Measure the distance. The
difference between the
calculated distance and the
measured distance to the backsight
point is displayed.
Determine the direction, but
do not store the values. The
graduated circle is orientated.
Using the keyboard, enter the
coordinates for the station or
for the tie point. See chapter "Data
management".
Measure the distance
and determine the
direction, and store the measurement
block. The graduated circle is orientated.
The difference between the calculated
distance and the measured distance
to the backsight point is displayed.
Single-point orientation (quick station setup)
This function brings together in a sin-
gle dialog all of the relevant inputs
needed to set up the instrument from
scratch.
Activate the function "Quick-station
setup (QSET)".
Enter the numbers of the station point
and of the backsight point
respectively. The appropriate point is
immediately searched for in the data
file and, if the search is successful,
the coordinates will be assigned to
the station point and backsight point
without this fact being displayed.
\Quick station setup
Station Id : 1
Backs. Id : A
Inst. Ht. : 1.500 m
Refl. Ht. : 1.000 m
∆∆∆∆∆ HorizDist : ----- m
Measure to Backs.point
DIST CONT INPUT
MC
ALL REC I<>II VIEW QUIT
MAIN\Quick station setup
Station Id : 1
Inst. Ht. : 1.600
Stn.East : 726530.424 m
Stn.North : 256431.871 m
Stn.Elev. : 459.173 m
Set Station with REC or CONT
REC CONT
MC
QUIT
Station data are set.
Station data are set and are
stored in the measurement
file.
Measurement functions
Determine the direction
and store it, including
the previously-measured distance
where appropriate. The graduated
circle is orientated.
Activate controlled data
search within data file.
See chapter "Data management".