Leica Geosystems TPS1100 Professional Series - User Manual - Manual (Page 75)

75
TPS1100 - User Manual 2.2.1en System functions
6
10
12
21
26
Hz-angle measurement is carried out
after the distance has been
measured. Immediately afterwards all
data is stored.
The measurement block stored in the
meas.job corresponds with the active
recording mask.
Therefore the instrument
may only be moved after
data storage is complete.
This is signalled acoustically by the
third beep after the ALL key has been
pressed.
The data is automatically recorded
after the distance has been
measured. The distance, and all data
which depend on it, are then
displayed with the tag "-----", which
indicates that the data storage is
complete.
Measuring distances and angles together
with storage (ALL)
Storing station data (REC)
The station data (point number,
easting, northing, station height,
reflector height and instrument
height) are recorded in the
measurement job. The coordinates
are set as station coordinates.
Changing face (I<>II)
Positioning in the other face. Display
of DHz and DV. If the instrument is
turned so that these values are at
"0.000", the target becomes visible in
the telescope again. This aid is an
advantage under conditions of poor
visibility.
If the instrument is motorized, the
instrument automatically travels to
the other face.