Leica Geosystems TPS1100 Professional Series - User Manual User Manual
Page 76
76
System functions
TPS1100 - User Manual 2.2.1en
Enter the last point number to be
stored and use it as the current point
number.
Last point number (L.Pt.)
This function deletes the last GSI
block of the current measuring job.
With "Del B", a measuring block
(starting with WI11) or a code block
(starting with WI41) can be deleted.
Deleting the GSI block (Del B)
Manual distance entry
Enter the horizontal distance, which
was measured with a tape for
instance.
Immediately after confirmation of
input, the horizontal distance is
shown corrected for the geometrical
ppm. After the distance has been
entered, the V-angle is set to "hori-
zontal" 90° ( 100 gon ) or 270° ( 300
gon ). The coordinates are calculated
using the corrected horizontal
distance, the Hz-direction, and the V-
angle. Heights are always corrected
for earth curvature and are corrected
for refraction according to the
parameter settings.
The reflector height is
temporarily set to the value
for the instrument height and so there
is always a height difference of
"0.000".
The slope distance is the same as
the horizontal distance.