KEYENCE LS-3100/3100W Series - Manual (Page 12)

6
1-7. Connecting 2 Scanning Heads
CHAPTER 1 Preparation for Measurement
CAUTION
Do not connect or disconnect any cables while the power is ON. Otherwise,
the laser diode may deteriorate and/or may be damaged.
Note the following for connecting 2 scanning heads to the controller:
• These heads have been factory-set for use either as the HEAD1 or
HEAD2. Incorrect connection of the scanning heads will, therefore, result
in malfunction. To prevent this, first check the serial No. of each scanning
head, then check the serial No. of the HEAD1 and HEAD2 on the back of
the controller for correct connection. Each of the scanning heads must be
connected respectively to the HEAD1 or HEAD2 connector on the back of
the controller.
Next, follow the steps (1) through (4) on P4. and 5.
Connect the correct scanning
head to the HEAD1 or HEAD2
connector.
Serial No.
Serial No.
08.10.1, 10:49 AM 6