Mode, offset, and limit for ch2 – KEYENCE LS-3100/3100W Series User Manual
Page 45
39
CHAPTER 4 Functions and Controls
8
Use SET to display
"CH1=X"
9
Use UP/DOWN to move
cursor down.
10
Use SET to display
"CH2=Y".
After step 10, each time you press FNC, the subdisplay will show the current
measurement mode (one of NORMAL, P-P, PEAK, BOTTOM), OFFSET
value, and tolerance limits. Be sure to select the parameters for CH2 in the
same manner as you do for CH1.
MODE, OFFSET, and LIMIT
for CH2
Use FNC to select the MODE, OFFSET, and LIMIT parameters. Note that
only 3-step differentiation is available for CH2 and that its output is sent
through the corresponding control I/O connector pins.
Enter the desired parameters for MODE, OFS (OFFSET), and LIMIT.
➪ See P.40 for MODE, P.43 for OFFSET, and P.29 or LIMIT.
Procedure
1. First select the desired segment pair for the segment selectors and
equations for the output channels.
➪ See P.32 and P.35.
2.
Press FNC once to display the current measurement mode.
3.
Each time you press SET, the subdisplay will show sequentially "NOR-
MAL", "P-P", "PEAK", and "BOTTOM". Display the desired mode.
4.
Press FNC again to display the current OFFSET value.
5.
Enter the desired value, and press ENT to register.
* OFFSET value is factory-set to "0.0000". Do not change it unless
otherwise required.
6.
Press FNC again to display the current tolerance limits.
7.
Use UP/DOWN to move the cursor up.
8.
Enter the desired value, and press ENT to register.
9.
Use UP/DOWN to move the cursor down.
10. Enter the desired value, and press ENT to register.
C H
X
1 =
C H
X
2 =
+ Y
C H
X
1 =
C H
X
2 =
+ Y
C H
X
1 =
C H 2 = Y
08.10.1, 10:55 AM
39