KEYENCE LS-3100/3100W Series - Manual (Page 31)

25
Procedure ■ Switching between 3-step and 7-step differentiations
1. Use PRM to display "LIMIT" (on the subdisplay).
2. To switch between two types of differentiation, use UP/DOWN to move the
cursor up.
3. Each time you press SET, "7 CLASSES" and "3 CLASSES" are displayed
alternately. Choose the desired type of differentiation.
■ Turning comparator output function ON/OFF
1. Use PRM to display "LIMIT" (on the subdisplay).
2. Use UP/DOWN to move the cursor down.
3. Each time you press SET, "ON" and "OFF" are displayed alternately.
4. Display "ON" to obtain the comparator output function, or "OFF" to cancel
this output function.
■ Setting tolerance limits (3-step differentiation)
1. First select 3-step differentiation as mentioned above, then use LIMIT to
set the tolerance limits.
➪ See P.29
2. If you press PRM after having set the tolerance limits, "DIGIT SUPPRESS"
will be displayed.
■ Setting tolerance limits (7-step differentiation)
1. First select 7-step differentiation as mentioned above, then use PRM to
set the tolerance limit.
2. "HI1" and "LO1" will appear on the subdisplay. Use UP/DOWN to move
the cursor up for HI1 or down for LO1.
3. Enter the desired values and press ENT to register.
4. Press PRM.
5. "HI2" and "LO2" will appear on the subdisplay. Enter the desired values
and press ENT to register.
6. Press PRM to display "HI3" and "LO3", enter the desired values, and
press ENT to register.
CHAPTER 4 Functions and Controls
I M I L T
O N
7 C L A S S E S
I M I L T
O N
7 C L A S S E S
H 2 3 0 = 0 0 0
L O
. I
3 0 0 0 0 . = 2 -
0
0
I M I L T
O N
7 C L A S S E S
08.10.1, 10:54 AM 25