KEYENCE LS-3100/3100W Series - Manual (Page 34)

28
1. Use PRM to display "POSITION CHECK".
2. Align the transmitter and receiver in terms of the optical axis.
3. When two scanning heads are used, press PRM again to display
"HEAD2" above "POSITION CHECK", and align the second set of
transmitter and receiver.
CHAPTER 4 Functions and Controls
Turns ON/OFF the beep during panel key operation. BUZZER
Procedure 1. Use PRM to display "BUZZER" (on the subdisplay).
2. Use SET to display "ON" or "OFF".
U Z Z N B O E R
HEAD2 Selects whether to use two scanning heads or not.
Procedure 1. Each time you press SET, "ON" and "OFF" are displayed alternately.
2. Display "ON" to use two scanning heads or "OFF" to use just one head.
The controller must be equipped with the optional PC board for the second
scanning head. If not, an error message "H2-Err" appears on the main
display. In such a case, display "HEAD2 OFF" (on the subdisplay). This will
cause "H-Err" to appear on the main display. Then, turn OFF the power
once, then turn it ON again. You can now perform measurements using only
the first scanning head (HEAD1).
E A D H N 2 O
POSITION CHECK
(Model: LS-3033/3060 only)
Checks whether the transmitter and receiver are aligned in terms of the
optical axis of the laser. This alignment is required when these units are
removed from the detachable frame during operation.
➪ See "Mounting Scanning Head" in Chapter 5 on P.65 for details.
Procedure
E A D H 1
O S T P I O I N C H E C K
E A D H 2
O S T P I O I N C H E C K
08.10.1, 10:54 AM 28