KEYENCE LS-3100/3100W Series - Manual (Page 15)

9
CHAPTER 3 Quick Setup Procedures
How to Use This Chapter
The switches on the
right side of the front
panel are shown at the
center of the pages in
this chapter. The switches on the left
side of the front panel
are shown on the left
side of the pages in this
chapter. All massages on the
sub-display are shown
on the right side of the
pages in this chapter.
3-1. Common Settings
Setting the Number
of Measurements for
Averaging See page 93 for Measurement Procedures.
SET
512
256
128
64
32
16
8
AVE
SET
SET
.
.
.
.
A V E 1
M
0
O
2
V
4
E
A V E
S I M P L
1
E
A V E 2
A V E 4
• After initialization, the number of measurements for averaging is automati-
cally set to 1024. "----" appears on the main display for about 3 seconds,
even after a workpiece has entered the measurement range.
• The sampling time required for one measurement is 2.5 m sec. The
sampling time then required for 1024 measurements is 2.56 sec. (2.5 x
1024). The time required to display an averaged measurement changes
depending on the number of measurements being made.
If highly accurate measurement is needed, select 512 or higher as the
number of measurements for averaging.
08.10.1, 11:14 AM 9