KEYENCE LS-3100/3100W Series - Manual (Page 13)

7
CHAPTER 2
T
RIAL
O
PERATION
1. Connect the controller and scanning head(s). Make sure that the optical
axis of the transmitter and receiver are aligned before turning the power
ON. Aligning the optical axis is not necessary, however, when using the
single-body type scanning head or when the transmitter and receiver are
secured on the detachable frame.
2. Laser emission starts in approximately 5 seconds.
3. Make sure that the target is correctly positioned in the measurement area.
The measured value will be displayed shortly.
4. The LS controller has been adjusted to the following factory-settings:
Ref.
• DIA: Outer diameter measuring mode. ............................................... P.32
• 1024: Number of measurements for averaging .................................. P.21
• MOVE: Averaging method .................................................................. P.21
Therefore, the displayed value was measured in the above settings. Read
this manual carefully to use the desired settings on your LS controller. To
change each setting, see the table of contents for the corresponding page
No. Some of the most frequently-used operations are given below with the
reference page Nos.
Ref.
• Changing the measurement position of targets .................................. P.32
• Changing the number of measurements for averaging ....................... P.21
• Changing the measurement mode (NORMAL, P-P, PEAK, BOTTOM)P.40
• Measuring two values at a time .......................................................... P.32
• Using two scanning heads to measure (X+Y)/2 .................................. P.32
Do not connect or disconnect any cables while the power is ON. Otherwise,
the laser diode may deteriorate and/or may be damaged.
CAUTION
08.10.1, 10:52 AM 7