KEYENCE LS-3100/3100W Series - Manual (Page 38)

32
CHAPTER 4 Functions and Controls
• If you enter invalid numbers (other than 1 through 126) and press ENT,
the initial edge numbers will remain on the subdisplay.
• Basically, two numbers are entered in this mode. If by mistake you enter
the larger number on the left and smaller number on the right, and press
ENT, the smaller number will appear on the left and larger number on the
right.
• Clear objects can be used as targets only in DIA, EDGE1, and EDGE2
modes, but not in SEG (m,n) mode.
• Use CLR to delete any incorrect values.
• In the above example operation, if you need to change only the first edge
number, that is, from 2 to 1, follow only steps 1, 2, 3, and 6.
• Similarly, if you need to change only the second edge number, that is,
from 3 to 5, follow only steps 1, 2, 4, 5, and 6.
ENT
S E G ( 4, 3 )
S E G ( 3, 4 )
B B B B B FNC (Function)
Key
Is used for the following settings:
• Segment selector
Selection of measurement points (2-point simultaneous measurement)
• Segment check
Inhibiting output of measurements obtained under abnormal conditions
• Output channel
Selection of output channel for displaying measured values X and Y and
calculation of equations using these values
• MODE, OFFSET, and LIMIT for CH2
Selection of mode for CH2, offset value, and tolerance limit
Description of each setting is given below.
Segment Selector In this mode, two segments are to be specified for simultaneous 2-point
measurement. Just as with the SEG key, any of four types of segments can
be specified respectively for segment selectors X and Y. (See P.30.) By
selecting two different segments, the LS controller can measure two different
segments at the same time.
Note
08.10.1, 10:55 AM 32