KEYENCE AutoID - Manual (Page 45)

3-13
3-4 Editing Setup Files
MANAGING PROJECTS
3
How to Set Parameters
When you have finished registered the component devices of a project, set the parameters of the
devices as follows.
There are three ways of setting parameters:
• By setting parameters by individual device
• By batch-setting parameters for a specific device model
• By setting parameters by individual files of a registered device
For details on the settings of each device, see "Chapter 4 SETTING DEVICE OPERATIONS"
(page 4-1).
■ Setting parameters by individual device
When setting parameters by individual device, you can set parameters by individual device by
clicking the [Project] tab.
■ Batch-setting parameters for a specific device model
When the settings are common for a specific device model, you can batch-set parameters for the
specific model by clicking the [Unit] tab.