KEYENCE AutoID - Manual (Page 47)

3-15
3-4 Editing Setup Files
MANAGING PROJECTS
3
Sending/Receiving Parameters
Parameters set in AutoID Navigator are not reflected as they are in a device. They must be sent
to the device.
Follow the procedure below establish a communication connection and send the parameters.
To update a connection with a device, the personal computer installed with
AutoID Navigator must be connected to the controller by an RS-232C cable.
■ Establishing the connection with the controller
1
Click (connect) on the tool bar.
The communication in progress dialog box is displayed and communication with the device starts.
When the connection is established, an icon is displayed to the left of the device name and the
parameter send/receive buttons are enabled.
When the following screens are displayed, this indicates that the connection between the device
and personal computer, or between devices failed.
Make sure that cable connections are correct.
Note
The personal computer is not
connected to the device The connection between the
controller and head failed