KEYENCE AutoID - Manual (Page 72)

4-22
SETT
ING DEVICE OPER
A
T
IONS
4
4-4 SR-500 Series Settings
Timing Setting
This section describes the settings for the read timing conditions.
Item Description
Signal type
Select Level or One-shot. When selecting One-shot, set One-shot input time
as well.
Input state Select Normally open or Normally closed.
Input pulse width Select 2 ms or 10 ms.
Trg delay time Set the trigger delay time (0 to 9990 ms, 10 ms increment)
Test mode initiated
Set this when initiating the test mode when a trigger is input or the power
turns ON.
Cmd for trigger ON
Change the trigger input ON command within eight characters.
The default is LON.
Cmd for trigger OFF
Change the trigger input OFF command within eight characters.
The default is LOFF.
Power-on trigger Turns on the trigger when the power turns on.