8 rs-485 master unit (n-410) settings, Parameters to be set, 8 rs-485 master unit (n-410) settings -40 – KEYENCE AutoID User Manual
Page 90: Parameters to be set -40, Rs-485 master unit (n-410) settings -40
4-40
SETT
4
4-8
RS-485 Master Unit (N-410) Settings
Parameters to be Set
There are five parameter items to be set up for the RS-485 master unit (N-410). Switch to the
desired setting item by clicking the respective tab and set the parameters on that tab.
Registered devices are displayed when N-410 is selected at the selection area. To set parame-
ters, click the "Param" button to switch to the parameter setting display.
(1) Main setting
(3) Protocol setting (4) RS-232 setting
(5) RS-485 setting
(2) Slave setting
Setting Item
Description
See Page
(1) Main setting
This tab is for setting the operation mode and trigger.
(2) Slave setting
This tab is for setting the slave station to be connected.
(3) Protocol setting
This setting is for setting the protocol and PLC.
(4) RS-232 setting
This tab is for setting communication over an RS-232 connection.
(5) RS-485 setting
This tab is for setting communication over an RS-485 connection.