Before requesting service, Power source, Shooting – Panasonic NVS7EG User Manual
Page 107: English
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ENGLISH
Before Requesting Service
Power Source
Symptom
Cause
Action
Reference
Pages
•When using the Battery Pack: ■
Movie Camera does not turn on. I
► •Battery Pack is not attached.
•Attach it correctly.
22
► •Battery Pack is not charged.
• Charge it.
18
•When using the Battery Pack: ■
Movie Camera turns off soon.
► •Battery Pack is exhausted.
• Use a fuily charged one.
18
► •Shooting was paused for more than 6 minutes.
•Set the [OPERATE] Switch to “OFF” and then to
“CAMERA” again.
46
•When using the AC Adaptor: ■
Movie Camera does not turn on.
^ •AC Adaptor is not connected.
•Connect AC Adaptor correctiy to Movie Camera.
22
• Movie Camera does not turn on. ■
^ •[OPERATE] Switch is set to “OFF”.
•Set it to “CAMERA” or “VTR”.
46,92
• Movie Camera turns off soon. ■
► *Dew has formed inside.
•Wait several hours.
101
Shooting
• No picture appears in the Viewfinder.
•[OPERATE] Switch is set to “OFF",
• Set it to “CAMERA”.
46
^ •Lens Cap is attached.
• Remove it.
30
• Indications in the Viewfinder are not
clear.
^ •The Viewfinder is not extended.
• Extend it approx. 3 cm.
28
• •Eyepiece Corrector is not adjusted.
•Adjust it.
28
• •Lens is covered with dust or dirt.
•Clean it.
98
•Shooting cannot be started.
^ •Tab of the inserted cassette is broken out.
•Cover the tab hole with adhesive tape.
34
• •No cassette is inserted.
•Insert a cassette with intact erasure prevention
tab.
34
• •Tape has reached its end.
• Insert a new video cassette.
34
• Date and time cannot be recorded, w •Date and time are not set.
• Set the date and time.
26
• Date and time are not displayed in the
Viewfinder.
^ •[DATE/TIME] Button was not pressed.
• Press the [DATE/TIME] Button.
28
^ •Button Type Battery is exhausted.
• Replace it with a new CR2032type battery.
24
Playback
• No playback picture is reproduced.
► •[OPERATE] Switch is set to “OFF”.
• Set it to “VTR”.
92
► »Movie Camera is not connected to TV set or it is
connected incorrectly,
• Connect Movie Camera to TV set correctly.
86
► •Wrong channel is selected on TV set.
• Select the correct channel.
—
• Picture is not in colour. M •Colour adjustment of TV set is not made properly.
•Adjust colour control on TV set.
—
• Picture is not in colour or distorted. »Tracking is not adjusted.
•Adjust the tracking on the Movie Camera.
92
• Picture contains noise bars. • •Cue, Review or Still Playback is being performed.
•This is not a malfunction.
94
-107-