Panasonic NVS7EG - Manual (Page 82)

ENGLISH ILLUSTRATION
Inserting a Still Picture with Wipe
Editing
Using the Digital Wipe Function
Inputting a Still Picture into Memory
When the Movie Camera is in the shooting pause mode:
1
Slide the Cover to the left until it locks
with a click.
•The Movie Camera is now in the Digital Mode.
Press.
I »Press this button while aiming the Movie Camera at the
scene to be used for the still picture.
■ »The irhage in the Viewfinder stands still for approx.
2 seconds and this still picture is input into memory.
Starting to Shoot a Scene with the Still Picture
In the shooting pause mode;
Press.
•Thpi^StilJ picture from fhp,men|ory replaces ¡the moving
picture gradually, starting from the left side.
•The Movie Camera should be aimed at the scene,-which is
to be shot following the recording of the still picture.
4
5
Press.
•The still picture from the merfiory is now being recorded.
Press again.
•The mOvihgTicture again repilaces the stillpicture gradually,
startihg froth the right-side, and the'Shooting ofthe moving I
picture continues.
■ Canceling the Digital Wipe Function
Slide the Digital Mode Cover fully toWard the right.
Notes:
•When the Digital Mode is activated, the [I. STABILIZER] Button,
[DIGITAL ZOOM] Button, [SNAPSHOT REC] Button and [STILL/
STROBE] Button do not work.
•While recording a still picture in the Digital Image Mix Mode, or
while this mode or the High-Sensitivity Function is activated, the
Digital Wipe Function does not work,
•The still picture will only be stored in memory for as long as the
“D.WIPE” or “D.MiX” Indication is lit in the Viewfinder,
The indication goes out and the still picture is no longer stored in
memory when:
—the camera Recorder is turned off.
—the [GAIN UP] Button is pressed.
—the Digital Mode Cover is slid baokward.
-82-